![]() If you have some drivers built into your kernel, the list above willĬontain too many modules. To load everything that is needed, add this to /etc/modules: * Chip `Intel digital thermal sensor' (confidence: 9) Now follows a summary of the probes I have just done.Ĭhip `ITE IT8620E Super IO Sensors' (confidence: 9) (confidence 8, not a hardware monitoring chip) Next adapter: SMBus I801 adapter at f040 (i2c-6) Using driver `i2c-i801' for device 0000:00:1f.3: Intel Lynx Point (PCH)ĭo you want to scan it? (yes/NO/selectively): y Reasonably well on most systems, it has been reported to cause troubleĭo you want to probe the I2C/SMBus adapters now? (YES/no): y This is the most risky part, and while it works Lastly, we can probe the I2C/SMBus adapters for connected hardware Probing for `National Semiconductor LM79' at 0x290. Probing for `National Semiconductor LM78' at 0x290. ISA slots! Do you want to scan the ISA I/O ports? (yes/NO): y Yes, you do have ISA I/O ports even if you do not have any We have to write to arbitrary I/O ports to probe them. Some hardware monitoring chips are accessible through the ISA I/O ports. There, we have to read from arbitrary I/O ports to probe for such We first try to get the information from SMBIOS. Through which system health data may be retrieved, amongst other things. Some systems (mainly servers) implement IPMI, a set of common interfaces Noįound `ITE IT8620E Super IO Sensors' Success! ![]() Trying family `VIA/Winbond/Nuvoton/Fintek'. Trying family `National Semiconductor/ITE'. ![]() This is usually safe.ĭo you want to scan for Super I/O sensors? (YES/no): y Some Super I/O chips contain embedded sensors. (YES/no): yĪMD Family 12h and 14h thermal sensors. ![]() Some south bridges, CPUs or memory controllers contain embedded sensors.ĭo you want to scan for them? This is totally safe. It is generally safeĪnd recommended to accept the default answers to all questions, To load to use lm_sensors most effectively. This program will help you determine which kernel modules you need PS, I found this link pretty informative.# sensors-detect revision 6284 ( 14:00:33 +0200) So I'm going to mark this as solved for now while I monitor the GPU temps. Once I rolled back to an Nvidia driver, quiet fans and sensors-detect gave me all the fan data including for the GPU. Turned out that a Nouveau driver was loaded when I installed Mint. Long story short, the fan that was maxed out in Mint was the Nvidia GPU which I didn't see pop up in sensors-detect at all. What it did show was something that initially confused me - a nouveau device which it couldn't get any information on. After I ran pwmconfig, I was able to see some of the fans, but not the Nvidia GPU. I installed xsensors and it was able to pick up all the case fans and the CPU and they were running at relatively low speeds (it is cold in my room). ![]() I saw the arch linux thread and did install lm-sensors but sensors-detect had difficulty seeing any fans at all though it did give me the core temps. I have to lower the threshold to 300 to boot anything. That said, every time I lose power, the bios resets to alarm if the fans are lower than 600 rpm which appears to be the default but the fans are always turning much slower on a cold boot. Thank you ClixTrix - I do let bios control the fans. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |